SABINE SWM7000 - Specifications download pdf (Page 9)

LIT-SWA6SS-OP-050222.pmd - rr

WARNING!

Warning! This equipment must be earthed.

Caution! Risk of electric shock. Do not open.

Caution! Shock hazard. Do not remove covers. No user serviceable

parts inside. Refer servicing to qualified service personnel.

Warning! To reduce the risk of fire or electric shock, do not expose

this product to rain or moisture.

Attention! Cet appareil doit être relié à la terre.

Attention! Risque de choc électrique; ne pas ouvrir.

Attention! Risque de choc; ne pas oter les capots. Aucune pièce

accessible à l’intérieur. S’addresser à un technicien qualifié.

Attention! Pour réduire le risque d’incendie ou de choc électrique, ne

pas laisser l’appareil sous la plouie ou à l’humidité.

Achtung! Dieses Gerät muss schutzgeerdet sein.

Achtung! Gefar eines elektrischen Stormschlags. Gehause nicht

öffnen.

Achtung! Gefar eines elektrischen Stormschlags. Gehäuse nicht

öffnen. Keine con Benutzer zu bedienenden Teile im Geräteinneren.

Überlassen Sie das Gerät zu Servicezwecken nur geschultem

Fachpersonal.

Um Brandgefar oder das Risiko eines elektrischen Schlags

auszuschließen, das Gerät vor Nässe und Feuchtigkeit schützen.

Advertencia! Este equipo debe estar conectado a tierra.

Precaución! Reisgo de descarga eléctrica. No abrir.

Precaución! Riesgo de descarga eléctrica. No desmontar las tapas.

Piezas interiores no reparables por el usuario. Reparable sólo por

personal cualificado.

Advertencia! Para reducir el riesgo de incendio o de descarga eléctrica

no exponga este producto a la lluvia o humedad.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not cause

harmful interference; and (2) This device must accept any interfer-

ence received, including interference that may cause undesired op-

eration. Warning: Changes or modifications to this unit not expressly

approved by the party responsible for compliance could void the user’s

authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equip-

ment generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio TV technician for help.

Japanese EMI Compliance Statement

Cautions & Warranty

Canadian Compliance Statement

This digital apparatus does not exceed the Class B limits for radio

noise emissions from digital apparatus set out in the Radio Interfer-

ence Regulations of the Canadian Department of Communications.

Le present appareil numerique n’emet pas de bruits radioelectriques

depassant les limites applicables aux appareils numeriques de la class

B prescrites dans le Reglement sur le brouillage radioelectrique edicte

par le ministere des Communications du Canada.

The True Mobility Antenna Distribution Amp is designed to oper-

ate from standard AC power. Please be sure the power in your

area is compatible with the power requirements marked on the

rear of the unit. Using the wrong input voltage may cause perma-

nent damage to the unit and will void the warranty.

Operating Voltages:

100-130 VAC, 50/60Hz, 0.100A 250 Slow Blow Fuse

200-240VAC, 50/60Hz, 0.050A Type T Fuse

CAUTION - Implanted cardiac pacemakers or AICD devices:

Any source of RF (radio frequency) energy may interfere with normal functioning of the implanted device. All wireless microphones

have Iow-power transmitters (less than 0.05 watts output) that are unlikely to cause difficulty, especially if they are at least a few

inches away. However, since a beltpack transmitter typically is placed against the body, Sabine suggests attaching it at the belt,

rather than in a shirt pocket where it may be immediately adjacent to an implanted medical device. Note also that any medical-

device disruption will cease when the RF transmitting source is turned off. Please contact your physician or medical-device provider

if you have any questions, or experience any problems with the use of this or any other RF equipment.

1. Read all safety and operating instructions before using this prod-

uct.

2. All safety and operating instructions should be retained for future

reference.

3. Obey all cautions in the operating instructions and on the unit.

4. All operating instructions should be followed.

5. Use only shielded audio and data cables.

6. This product should not be used in the presence of moisture or

rain, or near any water, i.e., a bathtub, sink, swimming pool, wet

basement, etc.

7. This product should be located so that its position does not inter-

fere with proper ventilation. Do not use in direct sunlight. Do not

place flat against a wall or in a built-in enclosure that will impede

the flow of cooling air.

8. This product should not be placed near a source of heat such as

a stove or radiator.

9. Connect only to a power supply of the type marked on the unit

adjacent to the power entry module.

10. Never break off the ground pin on the power supply cord.

11. Power supply cords should always be handled carefully. Never

walk or place equipment on power supply cords. Periodically check

cords for cuts or signs of stress, especially at the plug and the

point where the cord exits the unit.

12. The power supply cord should be unplugged when the unit is to

be unused for long periods of time.

13. Care should be taken so that objects do not fall and liquids are

not spilled into the unit through the ventilation holes or any other

openings.

14. This unit should be checked by a qualified service technician if:

A. The power supply cord or plug has been damaged.

B. Anything has fallen or been spilled into the unit.

C. The unit does not operate correctly.

D. The unit has been dropped or the enclosure damaged.

15. The user should not attempt to service this equipment. All service

work should be done by a qualified service technician.

Japan 100 VAC

U.S./North America 120 VAC

Continental Europe 230 VAC

United Kingdom 240 VAC

Australia 240 VAC

The True Mobility Antenna Distribution Amplifier is supplied with one

of the following AC power cords:

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

SABINE SWM7000 - Specifications Page 9

Comments to this Manuals