SM-610 Front & Back Panels
9
ACTIVE/BYPASS
In Active mode, the unit controls feedback automatically. The
two-color "BY" LED lights green when the unit is in Active mode
and lights red when in Bypass mode. Phantom power and the
mic preamp remain active in Bypass mode; only the FBX function
is bypassed.
12VDC ADAPTOR
The FBX external power supply (single unit power supply;
model #S-PSU1) is included with the unit. Use of any other
power supplies may cause permanent damage to the unit and
WILL VOID THE WARRANTY.
LOCK FIXED FILTERS
When the "LOCK FIXED" button is pressed, its LED will light to
indicate that the FBX is in "LOCK FIXED" mode. "LOCK FIXED"
mode can be activated at any time after system setup and will
stay on until the button is pressed again and the LED turns off.
FILTER ACTIVITY
When one of the unit’s filters is activated, the corresponding LED
lights. A blinking LED indicates the filter that was most recently
activated.
RESET
Press until the LEDs stop flashing to reset or clear all filters.
MIC GAIN
Use this to control the microphone preamp level. Adjust it as high
as possible without lighting the SOLO's red CLIP LED.
MEMORY:
The FBX stores the positions and depths of the filters in nonvolatile internal memory when the unit is turned off or during a power
failure. The unit will return all filters to their previous frequencies and depths when it is turned back on.
BYPASS MODE:
The SL-610 has a true power-off bypass. The signal is unaffected in bypass mode even if the unit is turned off. If the
unit is in active mode, no signal will pass if the power is off.
Placing the SM-610 in bypass mode only shuts down the FBX function; the microphone preamp still functions when the
unit is in bypass mode. The SM-610 will not pass signal if the power is off in either active or bypass mode.
RESETTING THE FILTERS:
The user must reset the FBX if the microphones or speakers are moved significantly. To reset the unit, press RESET until the LEDs
stop flashing.
POWER DOWN:
Place the unit in BYPASS MODE before removing power from the unit.
INPUT
The input accepts unbalanced TS (Tip/Sleeve) 1/4" phone plug,
balanced TRS (Tip/Ring/Sleeve) 1/4" phone plug, or balanced
XLR-3 (PIN 2 high) plug.
OUTPUT
Use unbalanced TS 1/4" phone plug for unbalanced mixer line
inputs. Use balanced TRS 1/4" phone plug (tip high) for balanced
mixer line inputs.
FILTER WIDTH SWITCH
Switch to narrow 1/10-octave filters for music applications or to
wider 1/5-octave filters for spoken word applications. The change
takes effect only on power up. Selecting a new width has no effect
unless you power down and then power up again.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals